PA Jeeps
The Garage => Technical Advice and Questions => Topic started by: BennyLT on April 08, 2008, 10:13:20 am
-
This weekend I am doing the MC2100 swap and HEI distributor swap at the same time.
My hope is to eliminate the ignition wiring problems I am having right now. Bad computer or bad module, or both. Don’t care since they are both being bypassed.
I am also having dash wiring problems. The PO partially installed a used harness. It is having all sorts of problems. I don’t care much about most of them. I just need to get my turn signals, wipers, and horn to work to pass inspection. I’ll worry about the gauges later….. what radio?
Once the module and computer are eliminated, isn’t a good portion of the under hood, and under dash harnesses not needed? Would it be a dumb idea to try to just disconnect the dash harness and run new wires directly to the fuse block to control the signals, wipers, horn etc… rather then try to diagnose the problem existing within the harness?
The dash problem is essentially that nothing works right except the head lights & marker lights. Turn signals don’t work, horn doesn’t work, and the dash lights want to be on all the time like they are connected to a hot lead right from the battery. BTW should they be switched by the headlight switch or the ignition?
Any opinions on keeping and trying to fix the harness Vs. rewiring the needed circuits as stand alone?
-
Sounds like a big mess. I cant see what re wiring would hurt and I'm thinking you would not want all those other wires going who knows where (fire hazzard). After market harnes may be your best bet.
Ted
-
if i wuz you, i would start over - with a new painless harness. then you know whats what and whats where...
-
I was hoping against buying a painless harness bacause now that i have eliminated both the module and the computer, i would be paying for a whole lot of engineering that i no longer need.
I think painless makes a fuse block by itself that maybe i could use and wire to, instead of paying big $$$ for the whole harness.
-
painless sucks. instaled 3 of them,then tryed ron francis wiering harness,far supireor product gives you more options. they also alow you to set it up with wichever ignition you want.