PA Jeeps
The Garage => Technical Advice and Questions => Topic started by: MudSlinger on August 25, 2009, 11:11:18 am
-
what all will i need to do the conversion to rear disc on my 95 xj from a zj as far as parts going to junk yard to get the parts.
-
just did this on mine pre-jeep show. i got the backing plate, caliper ,bracket, and soft line off the zj. clearancing the hole took a little while to get it right and get the four stud holes to line up. got the proportioning valve but read on naxja it wasnt needed so i didnt put it on. works fine 2 months now. used 2 tiny u clamps to hook the ebrake together. the hardest part of all was pulling the little tiny funky bolt in the pumpkin assembly to remove the cross pin its like a 7.5 mm. hope it helps
-
yes it does what year and rear did you get them off i got an 8.25 in the xj so what year and axle do i need to pull off the zj
-
it was a d44 rear and i think a 97/98.