PA Jeeps

The Garage => Technical Advice and Questions => Topic started by: CRJeepin on December 06, 2013, 11:47:46 pm

Title: T150 Rebuild question
Post by: CRJeepin on December 06, 2013, 11:47:46 pm

Rebuilding the T150 from my 79 CJ-5 (slowly - been stalled on the entire project over a year).

About have it back together and checking engagement of all the gears and not sure I have reverse and neutral set up right.  Anybody that knows how she oughtta engage want to trade a few beers for a checkup of it?  Would hate to find out it's wrong before I put it back under.

Have a rebuild kit from Novak and the factory service manual I've followed, so I think I've done OK with it but just want to be sure.

Or any ideas of a shop that might only charge a few bucks to go over it would be appreciated too.  I'm right in York near Mt Rose and I-83.

Thanks
Chris

Title: Re: T150 Rebuild question
Post by: Rick_Bear on December 08, 2013, 05:13:06 pm

Honestly I never cared for the T-150 trans and swapped them out rather than mess with them. A fine 3-Speed "street" trans but all but useless off road IMO.

Good Luck

Title: Re: T150 Rebuild question
Post by: Davew on December 09, 2013, 01:14:38 pm

put the synchronizers in neutral and spin input shaft , the output shaft shound not spin .
put the synchro in reverse spin input shaft clockwise and output shaft should turn counter clockwise.