« Reply #5 on: September 13, 2008, 06:25:20 pm »
These flares are designed to fit the factory holes for the most part. You will have to redrill a few small holes in the front wheel well and make two cuts in it to accomodate the new flare attachment mounting location. Overall my son and I had all of them installed in about 3 hours.I did check into the driveshaft problems with the lift and as long as you drive "normally" off and on the roads I was told they should be OK. Now this is going to be my next upgrade though because I tow my Polaris alot and this does put extra strain on them,just can not afford them now
If you have any more ? feel free to ask.
Logged
2008 jk 35" bfg's, 4'lift, disco's, diff covers, 4:88's, limited slip front and rear, cold air intake, "cherry bomb" catback exhuast, Hypertec max programmer, bushwaker flares, stainless steel bumpers and nerf bars,coverking seat covers, cb
2007 liberty daughters daily driver.