Author Topic: YJ water leaking in and Fan noise?  (Read 6543 times)

YJ Paco

  • Guest
YJ water leaking in and Fan noise?
« on: March 07, 2008, 11:54:02 am »
I have water that dribbles/runs in from the heater snouts at my feet. I was told that drain holes outside must be clogged. Where are this holes?

My heater fan only comes on at the top setting and is really noisy like a bearing has gone. How do I get to this fan to check or anyone have anyinout on what I should be checking?

Thanks again ..

obijon

  • Guest
Re: YJ water leaking in and Fan noise?
« Reply #1 on: March 12, 2008, 07:15:11 pm »
   drain holes outside? i dont know about that, but check the rubber around the wires where they come thru the firewall and stuff any openings
with some silicone tub caulk - it works good. as for the fan noise, the blower is on passenger side under the dash, and if it only blows on hi the
resistor is probably shot (more electrical resistance, slower speed). get a chlitons manual and take a trip to your junkyard and you will have it fixed in no
time at all..dive in and do it!  ;D

chasm

  • Hero Member
  • ****
  • Posts: 1045
  • Blonde / Bomber...
    • View Profile
    • JeepChasm
Re: YJ water leaking in and Fan noise?
« Reply #2 on: March 18, 2008, 03:07:55 pm »
I had the same water leak in my 93 YJ. The vent on the cowl will fill up with water if the drain tube is clogged. If your screen under the vent grille is bad, it will allow leaves and debris to clog the tube. Water will fill up and then come in through your heater ducts... sometimes dousing your left leg real good when you make a turn! :o

Take the grille off and clean out any debris you can see from the top and fix the screen. Under the hood, you will find a black rubber drain tube about 1" diameter close to center at the firewall. The tube is crimped flat at the end and has a piece of spring steel in the end to keep it closed so you are not sucking engine compartment fumes into the passenger compartment. Sometimes, you can just squeeze the end and the spring steel will allow the tube to open up and dump its' contents. Usually, the rubber tube is old and stiff and the spring steel doesn't like to flex. In this case, you may have to go underneath and stick a long flat screwdriver into the tube to clean out the debris and open it up. CAUTION: If there is still any water in there, it WILL run down your arm, so plan accordingly! BE SURE TO WEAR SAFETY GLASSES TOO! ;) You may wish to check your handywork with a garden hose to be sure the drain flows freely after you're done!

Hope this helps...
Mike Hardesty aka: "chasm"
'51 CJ3A: Restored Garage Queen
'83 CJ8 Scrambler: To Do List...
'93 YJ: 2.5" R.E. lift, 31" Swamper SSR's, Olympic Rock bumper, smashed Stainless exhaust, U-bolt skids, Warn M-8000 winch.
'08 Liberty: (wife's DD)