Author Topic: dana 44 / cherokee  (Read 10668 times)

hillbilly

  • Hero Member
  • ****
  • Posts: 1491
  • adam lewis - appalachian american - B.O.D.
    • View Profile
dana 44 / cherokee
« on: October 24, 2008, 03:41:23 pm »
this may have already been discussed but i cant find it anywhere.   will dana 44's from a wagoneer fit properly under a 84-01 style cherokee.  i know the wag has front leaf springs but will the rear be a "simple" bolt in?
build it, beat it, break it, fix it, repeat
A member of the church requests to be buried in his jeep because "It ain't never been in a hole it couldn't get out of."
   91 xj 8.5" lift -33" x 12.50 and my own additions
 94 xj (wifes) 3.5" lift and the boys 1979 cj7

CJ8Ted

  • Hero Member
  • ****
  • Posts: 482
    • View Profile
Re: dana 44 / cherokee
« Reply #1 on: October 24, 2008, 04:28:08 pm »
Not a "simple" bolt in. IMO Width, drive shaft length, I think the perches are different, lug bolt pattern.
 
Ted
85' CJ8 on 33s w/ 4.56s

hillbilly

  • Hero Member
  • ****
  • Posts: 1491
  • adam lewis - appalachian american - B.O.D.
    • View Profile
Re: dana 44 / cherokee
« Reply #2 on: October 24, 2008, 04:51:19 pm »
iyo is it worth the work?      ps you still looking for a dana 30 high pinion?
build it, beat it, break it, fix it, repeat
A member of the church requests to be buried in his jeep because "It ain't never been in a hole it couldn't get out of."
   91 xj 8.5" lift -33" x 12.50 and my own additions
 94 xj (wifes) 3.5" lift and the boys 1979 cj7

(Tattoo) Jack

  • Hero Member
  • ****
  • Posts: 810
  • Jack Utter
    • View Profile
Re: dana 44 / cherokee
« Reply #3 on: October 24, 2008, 05:18:20 pm »


   Swapping out the rear according to Eric Zappe's book... Some MJ's came with Dana 44's, but they're sprung Leaf-Under, but are almost identical to XJ Dana 44's. Ford 8.8 out of a '95 or newer Explorer is 31 spline, .75" narrower and some later models have Disk Brakes. Caveat: these have had cases where the Tubes have spun on the center housing so they should be welded. I know the Ranger runs the same BP as an XJ soooo I'll assume the Explorer does too.
   Front Dana 44: '80's or newer Wagoneer and Grand Wagoneer's, but they are 1" wider and are Leaf sprung. I think RE and some others have a conversion kit for Coils. But they are 6 on 5.5 bolt pattern, but they can be converted to 5 on 5.5. I don't know if you can change them to what we run, 5 on 4.5 and they're LOW-pinion!!! :( Something to think about.
   I'll try and remember to bring the book over so you can look at it.

   Tattoo 8)
The only way to know your limits...  is to surpass them!


                    Don't Shop - Adopt
   "Save Your Best Friends Life, Adopt a Rescue"
       If it's not a Dobermann, it's just a Dawg...

CJ8Ted

  • Hero Member
  • ****
  • Posts: 482
    • View Profile
Re: dana 44 / cherokee
« Reply #4 on: October 24, 2008, 06:55:39 pm »
iyo is it worth the work?      ps you still looking for a dana 30 high pinion?

No I don't think it is worth the work/$

No, I'm not looking at the momment
85' CJ8 on 33s w/ 4.56s

hillbilly

  • Hero Member
  • ****
  • Posts: 1491
  • adam lewis - appalachian american - B.O.D.
    • View Profile
Re: dana 44 / cherokee
« Reply #5 on: October 31, 2008, 03:51:16 pm »
turns out they were dana 60's whod a thunk it , going to get them anyway someone might need them.
build it, beat it, break it, fix it, repeat
A member of the church requests to be buried in his jeep because "It ain't never been in a hole it couldn't get out of."
   91 xj 8.5" lift -33" x 12.50 and my own additions
 94 xj (wifes) 3.5" lift and the boys 1979 cj7

Rick_Bear

  • Hero Member
  • ****
  • Posts: 2077
  • Jeep Show Chairman
    • View Profile
Re: dana 44 / cherokee
« Reply #6 on: November 01, 2008, 07:22:35 am »
Dana 60's are "BIG BEEF" man
Do Your Duty And History Will Do You Justice...!
06' Wrangler Rubicon Unlimited, Clayton 4" Long Arm Suspension, Clayton Full Skid Plates, AtoZ Fabrication Rock Sliders, AtoZ Fabrication Cage Addition and More modifications to come...