Author Topic: What did you do to your Jeep today?  (Read 811792 times)

Death Wobble

  • Hero Member
  • ****
  • Posts: 942
  • Angie Zinn - Wall St. Warrior
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1050 on: October 19, 2011, 01:16:05 pm »
It passed state inspection!  ;D
'88 XJ Limited:  4.5" ZONE lift, 32x11.5x15 BFG KM2s, JKS Quicker Discos, Kevin's Off Road rock rails.
'96 XJ Sport: 31x10.5 BFGs, 3" Rusty's lift.
Listen to Clutch.
(and your gut instincts)
CENSORSHIP IS UNAMERICAN!

squazz

  • Jr. Member
  • *
  • Posts: 64
  • Flexable
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1051 on: October 19, 2011, 01:29:09 pm »
Yesterday I got some tabs I cut out of scrap steel welded up for my fairlead after my welding attempts failed I really wish I could weld id have so much more compleated

and the reason I prob should had done this sooner


Any recomndations on where to get a replacement or if I should go synthetic?
98 Zj                    93 Zj                        94 Zj         
  5.9L 46re              4.0L Ax-15          Gone But not forgotten
1"+ Up County    5.5" IRO front          
                        Clayton rear long arms


¯\[°_o]/¯ Charles Howard

Jeremy

  • Full Member
  • **
  • Posts: 241
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1052 on: October 23, 2011, 10:28:18 pm »
I have been very happy with a synthetic road from winchlines.com   I wnet with their "fireline" which has a high heat tolerance.  Get a cover for your winch if you go synthetic though as UV light can damage the rope.


As for what I did to my jeep today? I went out to a paintball field owned by a friend of mine to do a "work day"  and got my Red scrambler stuck and broken in some of the nastiest mud I have seen,  it has the consistency of wet pottery clay and was bottomless,  Broken my clutch linkage and my winch failed due to a corroded connection,  did I mention that I had no tools with me.   Got it out and limped home. 
 
Jeremy Meehan

Death Wobble

  • Hero Member
  • ****
  • Posts: 942
  • Angie Zinn - Wall St. Warrior
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1053 on: November 01, 2011, 08:16:18 pm »
Took it to Mt. Zion and got a few things checked out and tweaked.  Then, we stood around and talked a lot.   :)
'88 XJ Limited:  4.5" ZONE lift, 32x11.5x15 BFG KM2s, JKS Quicker Discos, Kevin's Off Road rock rails.
'96 XJ Sport: 31x10.5 BFGs, 3" Rusty's lift.
Listen to Clutch.
(and your gut instincts)
CENSORSHIP IS UNAMERICAN!

Rick_Bear

  • Hero Member
  • ****
  • Posts: 2077
  • Jeep Show Chairman
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1054 on: November 02, 2011, 01:34:16 am »
Any recomndations on where to get a replacement or if I should go synthetic?
Upgrade to synthetic line. You won't regret it.
Do Your Duty And History Will Do You Justice...!
06' Wrangler Rubicon Unlimited, Clayton 4" Long Arm Suspension, Clayton Full Skid Plates, AtoZ Fabrication Rock Sliders, AtoZ Fabrication Cage Addition and More modifications to come...

MUDDY

  • Sr. Member
  • ***
  • Posts: 263
  • Jon Vasellas
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1055 on: November 09, 2011, 10:44:56 pm »
SOLD THE 88 XJ TODAY. DIDNT WANT TO BUT SHE WAS EATING A HOLE IN MY POCKET IN GAS. LOOKING FOR A STOCK JEEP NOW THEN COME TAKE TIME IM GOING TO FIND A WAGONEER AND MAKE A BUGGY. THIS IS JUST WISHFUL THINKING.
98 grand cherokee mild liFT
97 CHEVY 3IN LIFT

hillbilly

  • Hero Member
  • ****
  • Posts: 1491
  • adam lewis - appalachian american - B.O.D.
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1056 on: November 11, 2011, 03:42:06 pm »
well after the stress of life was just too much i decided to go wheelin , by myself. not a good idea. the winch worked great but the sheard off axle shaft up front put a stop to it, ive never broke off all 4 yoke ears at one time. but after all the carnage it puts everything back in perspective.   :D
build it, beat it, break it, fix it, repeat
A member of the church requests to be buried in his jeep because "It ain't never been in a hole it couldn't get out of."
   91 xj 8.5" lift -33" x 12.50 and my own additions
 94 xj (wifes) 3.5" lift and the boys 1979 cj7

Rick_Bear

  • Hero Member
  • ****
  • Posts: 2077
  • Jeep Show Chairman
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1057 on: November 16, 2011, 02:52:49 am »
It's not what I did today, but is what I've been trying to accomplish over the past two months. Frustration couldn't explain how I've felt...
I've been determined to get this CJ-5 out for another trail ride in about a two year period and had to encounter MANY CJ issues to keep things short.

Well, enough was enough so I made a phone call to my/our friend Mount Zion Off-Road.

I'll quote Mike's email when my CJ was finally ready after a 30 stay in their care...Take in mind I did tell Mike I wasn't in a hurry, I just wanted things corrected. It would “fire”, and I knew it wasn’t just a grounding issue.
That might have been the wrong thing to say :) for Mike and myself.

"We were pulling our hair out with your Jeep, but finally figured everything out"
I’m not a fan of tracing wires…Personally I’d rather eat dirt. Wow, did this CJ have issues. Here’s the list…
1)   Starter Solenoid (Sticking-Starter ON)
2)   Ignition Switch (Power wire from fuse box to relay had broken)
3)   20 amp fuse
4)   Ignition Module
5)   Distributor Replaced (Used)
6)   Distributor Pick-Up wire was bad
7)   Fuse for fuel pump relay was bad and replaced.

I’m picking it up Friday, am unavailable to go wheeling Saturday so I’m heading back down to the lower end of my property to exert some “testosterone” and just might have another interesting write up for the Club’s Newsletter.
I'll add this too...It pays to have a stored inventory of variuos parts...and Nancy calls it junk..."She has NO clue".
My reply: If I can't use it someone I come accross will be able to... :)
Mike Hardesty liked my last property story (few years back) so I just might enlighten his day again with another.  ;D
Do Your Duty And History Will Do You Justice...!
06' Wrangler Rubicon Unlimited, Clayton 4" Long Arm Suspension, Clayton Full Skid Plates, AtoZ Fabrication Rock Sliders, AtoZ Fabrication Cage Addition and More modifications to come...

Ron Allen

  • Full Member
  • **
  • Posts: 142
  • PA Jeeps B.O.D.
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1058 on: November 16, 2011, 06:15:56 pm »
Glad to hear your back on your beadlocks, Rick
03 Rubicon Way Modified
44 MB WWII restored
46 CJ2A Locked,injected,Ready
13 F350 Tow Rig

chasm

  • Hero Member
  • ****
  • Posts: 1045
  • Blonde / Bomber...
    • View Profile
    • JeepChasm
Re: What did you do to your Jeep today?
« Reply #1059 on: November 21, 2011, 03:23:31 pm »
I’m picking it up Friday, am unavailable to go wheeling Saturday so I’m heading back down to the lower end of my property to exert some “testosterone” and just might have another interesting write up for the Club’s Newsletter.
I'll add this too...It pays to have a stored inventory of variuos parts...and Nancy calls it junk..."She has NO clue".
My reply: If I can't use it someone I come accross will be able to... :)
Mike Hardesty liked my last property story (few years back) so I just might enlighten his day again with another.  ;D

Well Rick, did ya break anything???
Mike Hardesty aka: "chasm"
'51 CJ3A: Restored Garage Queen
'83 CJ8 Scrambler: To Do List...
'93 YJ: 2.5" R.E. lift, 31" Swamper SSR's, Olympic Rock bumper, smashed Stainless exhaust, U-bolt skids, Warn M-8000 winch.
'08 Liberty: (wife's DD)

Jeremy

  • Full Member
  • **
  • Posts: 241
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1060 on: November 28, 2011, 12:21:52 pm »
<iframe width="560" height="315" src="http://www.youtube.com/embed/VyWpx0A8jXs" frameborder="0" allowfullscreen></iframe>

Just in case the embed did not work:  http://youtu.be/VyWpx0A8jXs

Why does something inane begin with "hold my beer" Anyway, I thought I would share stupid with the rest of you.

As for what is going on with my jeeps,  1982 is getting  converted to a hydraulic clutch linkage.  My 1981 is down at Adventurous 4wheel drive for 4.10 gears, once piece axle shafts and a lockright locker that I bought 17 years ago and never installed.  The plow lifting frame is installed and the bottom frame is close. 
Jeremy Meehan

Scott Gibson

  • Full Member
  • **
  • Posts: 120
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1061 on: November 28, 2011, 08:25:41 pm »
I had a BDS lift, Fox shocks,and some 37'' Swampers installed today.

Keith

  • Newbie
  • *
  • Posts: 34
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1062 on: November 29, 2011, 05:31:17 am »
That's cool Scott. Now we got to get out and "break" it in ;D

MUDDY

  • Sr. Member
  • ***
  • Posts: 263
  • Jon Vasellas
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1063 on: December 04, 2011, 07:48:15 pm »
THE TRANS IN THE GRAND CHEROKEE BLOW OUT ON I-81 32 MILES FROM BRISTOL TN. TOWED HER HOME . PUT IT IN ANY GEAR AND WONT EVEN MOVE. TIME TO RIP IT OUT IN THE NEXT COUPLE WEEKS. WHAT A JOB.
98 grand cherokee mild liFT
97 CHEVY 3IN LIFT

Scott Gibson

  • Full Member
  • **
  • Posts: 120
    • View Profile
Re: What did you do to your Jeep today?
« Reply #1064 on: December 04, 2011, 07:55:25 pm »
De-badged it and shortened the front bumper 18 inches.