Hi,
I am trying to install a manual throttle on my YJ, and I'm almost done, but I can't figure out how to get the cable to stay secure at the linkage. I have the cable looped around the linkage and back thru the cable chip/clamp, parallel with itself, but I cannot get it to secure the two cables together. Is the cable chip/clamp supposed to clamp around the two cables? Or am I completely off on this one? I tried to attach a picture of it from the manual, but apparently the upload folder is full and will not take my file. sigh
This is the one I have and the instructions are there. It's the second picture on the 3rd page of the install instructions.
Thanks in advance,
Leonard